[Home ] [Archive]   [ فارسی ]  
:: Main :: About :: Current Issue :: Archive :: Search :: Submit :: Contact ::
Main Menu
Home::
Journal Information::
Articles archive::
For Authors::
For Reviewers::
Registration::
Contact us::
Site Facilities::
::
Social Network Membership
Linkedin
Researchgate
..
Indexing Databases
..
DOI
کلیک کنید
..
ِDOR
..
Search in website

Advanced Search
..
Receive site information
Enter your Email in the following box to receive the site news and information.
..
:: Volume 6, Issue 2 (3-2018) ::
ieijqp 2018, 6(2): 34-45 Back to browse issues page
Fault Ride through Capability Improvement of the DFIG-Based Wind Turbine in Microgrid
Arman Safaeei1 , Seyed Hossein Hosseinian1 , Hossein Askarian Abyaneh * 1
1- Amirkabir University of Technology
Abstract:   (7938 Views)

Using of DFIG-Based wind turbine in distribution network is increasing day by day. Despite different advantages of DFIG such as ease controllability, low cost and ability to work in different wind speeds, they are very sensitive to the grid voltage drop and when a fault occurs, the rotor current is increased and this may leads to damage the DFIG power electronics converters. Also, voltage swell caused by large loads switching off, large capacitor banks energizing and unbalanced faults may damage the DFIG converters. Dou to necessity of compliance of grid codes, a novel approach is proposed in this paper to improve the low voltage ride through (LVRT) and high voltage ride through (HVRT) capability of the DFIG in microgrid by using superconducting magnetic energy storage (SMES) and superconductive fault current limiter (SFCL), simultaneously. The simulation is carried out by using PSCAD/EMTDC software and the simulation resultsillustrate the effectiveness of proposed approach to improve fault ride through capability of DFIG in microgrid during voltage swell and voltage sag.

Keywords: Doubly-Fed Induction Generator (DFIG), Micro Grid, Lowvoltage Ride-Through (LVRT), High Voltage Ride-Through (HVRT)
Full-Text [PDF 1334 kb]   (1584 Downloads)    
Type of Study: Research | Subject: Special
Received: 2017/01/11 | Accepted: 2017/06/6 | Published: 2018/03/7
References
1. [1] R. C. Dugan and T. E. McDermott, "Distributed generation," IEEE Industry Applications Magazine, vol. 8, pp. 19-25, 2002.
2. [2] A. Safaei, B. Vahidi, H. Askarian-Abyaneh, E. Azad-Farsani, and S. M. Ahadi, "A two step optimization algorithm for wind turbine generator placement considering maximum allowable capacity," Renewable Energy, vol. 92, pp. 75-82, 2016.
3. [3] J. F. DeCarolis and D. W. Keith, "The economics of large-scale wind power in a carbon constrained world," Energy Policy, vol. 34, pp. 395-410, 2006.
4. [4] E. Hau, Wind turbines: fundamentals, technologies, application, economics: Springer Verlag, 2006.
5. [5] J. Hu, Y. Huang, D. Wang, H. Yuan, and X. Yuan, "Modeling of Grid-Connected DFIG-Based Wind Turbines for DC-Link Voltage Stability Analysis," IEEE Transactions on Sustainable Energy, vol. 6, pp. 1325-1336, 2015.
6. [6] M. F. M. Arani and Y. A. R. I. Mohamed, "Assessment and Enhancement of a Full-Scale PMSG-Based Wind Power Generator Performance Under Faults," IEEE Transactions on Energy Conversion, vol. 31, pp. 728-739, 2016.
7. [7] x, Huchel, M. S. E. Moursi, and H. H. Zeineldin, "A Parallel Capacitor Control Strategy for Enhanced FRT Capability of DFIG," IEEE Transactions on Sustainable Energy, vol. 6, pp. 303-312, 2015.
8. [8] A. H. Kasem, E. F. El-Saadany, H. H. El-Tamaly, and M. A. A. Wahab, "An improved fault ride-through strategy for doubly fed induction generator-based wind turbines," IET Renewable Power Generation, vol. 2, pp. 201-214, 2008.
9. [9] M. B. C. Salles, K. Hameyer, J. R. Cardoso, A. P. Grilo, and C. Rahmann, "Crowbar System in Doubly Fed Induction Wind Generators," Energies, vol. 3, pp. 738-753, 2010.
10. [10] G. Pannell, D. J. Atkinson, and B. Zahawi, "Minimum-Threshold Crowbar for a Fault-Ride-Through Grid-Code-Compliant DFIG Wind Turbine," IEEE Transactions on Energy Conversion, vol. 25, pp. 750-759, 2010.
11. [11] C. Wessels, F. Gebhardt, and F. W. Fuchs, "Fault Ride-Through of a DFIG Wind Turbine Using a Dynamic Voltage Restorer During Symmetrical and Asymmetrical Grid Faults," IEEE Transactions on Power Electronics, vol. 26, pp. 807-815, 2011.
12. [12] A. O. Ibrahim, T. H. Nguyen, D. C. Lee, and S. C. Kim, "A Fault Ride-Through Technique of DFIG Wind Turbine Systems Using Dynamic Voltage Restorers," IEEE Transactions on Energy Conversion, vol. 26, pp. 871-882, 2011.
13. [13]M. Molinas, J. A. Suul, and T. Undeland, "Low Voltage Ride Through of Wind Farms With Cage Generators: STATCOM Versus SVC," IEEE Transactions on Power Electronics, vol. 23, pp. 1104-1117, 2008.
14. [14]L. Chen, C. Deng, F. Zheng, S. Li, Y. Liu, and Y. Liao, "Fault Ride-Through Capability Enhancement of DFIG-Based Wind Turbine With a Flux-Coupling-Type SFCL Employed at Different Locations," IEEE Transactions on Applied Superconductivity, vol. 25, pp. 1-5, 2015.
15. [15] W. Guo, L. Xiao, S. Dai, X. Xu, Y. Li, and Y. Wang, "Evaluation of the Performance of BTFCLs for Enhancing LVRT Capability of DFIG," IEEE Transactions on Power Electronics, vol. 30, pp. 3623-3637, 2015.
16. [16] W. Guo, L. Xiao, and S. Dai, "Enhancing Low-Voltage Ride-Through Capability and Smoothing Output Power of DFIG With a Superconducting Fault-Current Limiter-Magnetic Energy Storage System," IEEE Transactions on Energy Conversion, vol. 27, pp. 277-295, 2012.
17. [17] T. Kinjo, T. Senjyu, N. Urasaki, and H. Fujita, "Terminal-voltage and output-power regulation of wind-turbine generator by series and parallel compensation using SMES," IEE Proceedings - Generation, Transmission and Distribution, vol. 153, pp. 276-282, 2006.
18. [18] Q. Huang, X. Zou, D. Zhu, and Y. Kang "Scaled Current Tracking Control for Doubly Fed Induction Generator to Ride-Through Serious Grid Faults," IEEE Transactions on Power Electronics, vol. 31, pp. 2150-2165, 2016.
19. [19] R. Zhu, Z. Chen, X. Wu, and F. Deng, "Virtual Damping Flux-Based LVRT Control for DFIG-Based Wind Turbine," IEEE Transactions on Energy Conversion, vol. 30, pp. 714-725, 2015.
20. [20] N. H. Saad, A. A. Sattar, and A. E.-A. M. Mansour, "Low voltage ride through of doubly-fed induction generator connected to the grid using sliding mode control strategy," Renewable Energy, vol. 80, pp. 583-594, 2015.
21. [21]H. M. El-Helw and S. B. Tennakoon, "Evaluation of the suitability of a fixed speed wind turbine for large scale wind farms considering the new UK grid code," Renewable Energy, vol. 33, pp. 1-12, 2008.
22. [22] M. Mohseni and S. M. Islam, "Review of international grid codes for wind power integration: Diversity, technology and a case for global standard," Renewable and Sustainable Energy Reviews, vol. 16, pp. 3876-3890, 2012.
23. [23] Z. Xing, Q. Tingyu, X. Zhen, and C. Renxian, "Dynamic analysis of doubly fed induction generator during symmetrical voltage swells," in Mechanic Automation and Control Engineering (MACE), 2011 Second International Conference on, 2011, pp. 1245-1248.
24. [24] W. J. Park, B. C. Sung, and J. W. Park, "The Effect of SFCL on Electric Power Grid With Wind-Turbine Generation System," IEEE Transactions on Applied Superconductivity, vol. 20, pp. 1177-1181, 2010.
25. [25]J. B. Ekanayake, L. Holdsworth, W. XueGuang, and N. Jenkins, "Dynamic modeling of doubly fed induction generator wind turbines," IEEE Transactions on Power Systems, vol. 18, pp. 803-809, 2003.
26. [26] R. Yuan and Z. Wei, "A novel control strategy of an active crowbar for DFIG-based wind turbine during grid faults," in 2011 IEEE International Electric Machines & Drives Conference (IEMDC), 2011, pp. 1137-1142.
27. [27]M. H. Ali, B. Wu, and R. A. Dougal, "An Overview of SMES Applications in Power and Energy Systems," IEEE Transactions on Sustainable Energy, vol. 1, pp. 38-47, 2010.
28. [28] A. Tomoki, T. Rion, T. Murata, J. Tamura, K. Masahiro, M. Yoshiharu, et al., "Evaluation method of power rating and energy capacity of Superconducting Magnetic Energy Storage system for output smoothing control of wind farm," in Electrical Machines, 2008. ICEM 2008. 18th International Conference on, 2008, pp. 1-6.
29. [29] Y. Shirai, K. Furushiba, Y. Shouno, M. Shiotsu, and T. Nitta, "Improvement of Power System Stability by Use of Superconducting Fault Current Limiter With ZnO Device and Resistor in Parallel," IEEE Transactions on Applied Superconductivity, vol. 18, pp. 680-683, 2008.
30. [30] L. Ye and A. Campbell, "Behavior Investigations of Superconducting Fault Current Limiters in Power Systems," IEEE Transactions on Applied Superconductivity, vol. 16, pp. 662-665, 2006.
31. [31] Y. Lin and K. P. Juengst, "Modeling and simulation of high temperature resistive superconducting fault current limiters," IEEE Transactions on Applied Superconductivity, vol. 14, pp. 839-842, 2004.
32. [32] S. Kar and S. R. Samantaray, "Time-frequency transform-based differential scheme for microgrid protection," IET Generation, Transmission & Distribution, vol. 8, pp. 310-320, 2014.


XML   Persian Abstract   Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Safaeei A, Hosseinian S H, Askarian Abyaneh H. Fault Ride through Capability Improvement of the DFIG-Based Wind Turbine in Microgrid. ieijqp 2018; 6 (2) :34-45
URL: http://ieijqp.ir/article-1-410-en.html


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Volume 6, Issue 2 (3-2018) Back to browse issues page
نشریه علمی- پژوهشی کیفیت و بهره وری صنعت برق ایران Iranian Electric Industry Journal of Quality and Productivity
Persian site map - English site map - Created in 0.06 seconds with 40 queries by YEKTAWEB 4645